Cycle Modifier Buttons; Option Buttons - LG DLE3500 Serie Manual Del Propietário

Cycle Modifier Buttons

Sensor Dry cycles have preset settings that are
selected automatically. Manual Dry cycles have
default settings, but you may also customize the
settings using the cycle modifier buttons. Press
the button for that option to view and select other
settings.
Dry Level
Use this button to select the level of dryness for the
cycle. Press the Dry Level button repeatedly to scroll
through available settings.
• This option is only available with Sensor Dry cycles.
• The dryer will automatically adjust the cycle time.
Selecting More Dry or Very Dry will increase
the cycle time, while Less Dry or Damp Dry will
decrease the cycle time.
• Use a Less Dry or Damp Dry setting for items that
you wish to iron.
Temp.
Use this button to adjust the temperature setting.
This allows precise care of fabrics and garments.
Press the Temp. button repeatedly to scroll through
available settings.
Time Dry
Use this button to manually select the drying time,
from 20 to 60 minutes, in 10-minute increments. Use
this for small loads or to remove wrinkles. Use the
More Time/Less Time buttons to add or reduce the
drying time in 1-minute increments.
Signal
Use this button to adjust the volume of the Signal or
turn off the Signal. Press the button repeatedly until
the desired volume setting is illuminated.

Option Buttons

The dryer features several additional cycle options to
customize cycles to meet individual needs. Certain
option buttons also feature a special function that
can be activated by pressing and holding that option
button for 3 seconds.
Adding Cycle Options to a Cycle
1
Turn on the dryer and turn the Cycle selector
knob to select the desired cycle.
2
Use the cycle modifier buttons to adjust the
settings for that cycle.
3
Press the cycle option button(s) to add the
desired options. A confirmation message is
shown in the display.
4
Press the Start/Pause button to start the cycle.
The dryer starts automatically.
Wrinkle Care
Selecting this option will tumble the load periodically
for up to 3 hours after the selected cycle, or until the
door is opened. This is helpful in preventing wrinkles
when you are unable to remove items from the dryer
immediately.
Damp Dry Signal
When this option is selected, the dryer signals when
the load is approximately 80% dry. This allows you
to remove faster-drying lightweight items or items
that you would like to iron or hang while they are still
slightly damp.
Energy Saver
This option helps to reduce the energy consumption
of the Normal Cycle, depending on the load size.
When the Energy Saver option is selected, the cycle
begins with an air dry section and the drying time is
increased.
OPERATION 39