Descargar Imprimir esta página

Velux KlC 500 Manual Del Usuario página 3

Ocultar thumbs Ver también para KlC 500:

Publicidad

English:
important inFormation
Warning – to rEDUCE thE
risK oF sEvErE injUry or
DEath:
safety
• Read instructions carefully before installing and operating.
• Please keep instructions for future reference and hand them over to any
new user.
• This device is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the device by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
device.
• Never let children play with the control unit or the remote control. The
remote control should be kept out of reach of children at a minimum
height of 5 feet (1.5 m).
• The product must not be put into operation until it has been fitted ac-
cording to these instructions.
• Before operating, ensure that the product can be operated without risk
of damage to property or injury to people or animals.
• If repair and adjustment work is needed, disconnect from the main
power supply and ensure that it cannot be reconnected unintentionally.
• The control unit must not be covered (maximum casing temperature:
104°F/40°C).
• This product has been designed for use with genuine VELUX products.
Connection to or use with other products may cause damage, malfunc-
tion or injury.
• The control unit has a Class 2 Low Voltage output (19-24 V d.c.).
• To reduce the risk of electric shock, this device has a polarized plug (one
pin is wider than the other). The plug will fit into a polarized outlet only
one way. If the plug does not fit fully into the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper
outlet. Do not change the plug in any way.
• Disconnect from the main power supply before carrying out any main-
tenance, repair, adjustment or service work to the skylight or products
connected to it (including control unit and, if installed, battery backup
KLB) and ensure that it cannot be reconnected unintentionally during
this time.
• The product requires a minimal amount of maintenance. The surface
may be cleaned with a soft, damp cloth using a small amount of house-
hold cleaner diluted in water.
• If main power supply cable is damaged, it must be replaced by qualified
electrical installer in accordance with all local codes, ordinances, rules
and regulations.
• FCC ID: XSG863892 and IC ID: 8642A-863892: control unit
Certificate of Radio Equipment in Japan: No. 10215037/AA/00
4 VELUX
This device complies with part 15 of the FCC and RSS-210 of the IC
rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
• This device has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and
can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined
by turning the device off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate the device.
• FCC Radiation Exposure Statement: This device complies with FCC RF
radiation exposure limits set forth for an uncontrolled environment.
• The term "IC:" before the device certification number only signifies that
the Industry Canada technical specifications were met.
• If you have any technical questions, please contact your VELUX sales
company, see telephone list or www.velux.com.
installation
• Installation must comply with all local codes, ordinances, rules and regu-
lations. When using a junction box for connecting multiple wires, please
ensure that the junction box is properly rated for that usage.
• The control unit is for indoor use only.
• Installation in rooms with a high level of humidity and with hidden wiring
must comply with relevant regulations (contact a qualified electrician if
necessary).
product
• The control unit can control up to five products of the same type. If
several products are activated simultaneously, they will be operated one
at a time and in random order.
• The control unit has a built-in RF (radio frequency) unit and will not be
operative if placed in a metal cabinet.
• Electrical products must be disposed of in conformity with all local
codes, ordinances, rules and regulations for electronic waste and not
with household waste.
• The packaging can be disposed of with usual household waste.
• Radio frequency band: 2.4 GHz.
• Radio frequency range: 110 yards (100 m) free field. Depending on
building construction, the indoor range is approx 30 ft (10 m). However,
constructions with reinforced concrete, metal ceilings and plaster walls
with steel members may reduce the range.
maintenance and service
• Spare parts are available through your VELUX sales company. Please
provide information from the data plate.
• There is no serviceable parts inside the product.
VELUX 5

Publicidad

loading

Este manual también es adecuado para:

Klc 500