Maintenance And Care; Installation Instructions; Mounting The Unit - Stiebel Eltron MINI 2-1 Funcionamiento E Instalación

INSTALLATION INSTRUCTIONS

» Check the filter screen for scale blockage or dirt accumulation.
See section 12, "Troubleshooting", pg. 19.
6.6

Maintenance and care

MAINTENANCE WORK, SUCH AS CHECKING ELECTRICAL
!
SAFETY, MAY ONLY BE CARRIED OUT BY A QUALIFIED
INSTALLER.
WARNING: ALWAYS SHUT OFF POWER AND WATER TO
THE UNIT PRIOR TO REMOVING THE FILTER SCREEN.
FAILURE TO DO SO MAY CAUSE SERIOUS BODILY INJURY OR
DEATH.
Regularly clean and descale the filter screen located in the cold water
inlet connection and if necessary replace. Always shut off power and
water to the unit prior to removing the filter screen.
A damp cloth is sufficient for cleaning of the unit's housing. Do not
use any abrasive or corrosive cleaning agents.
WWW.STIEBEL-ELTRON-USA.COM
7. Installation instructions
KEEP THESE INSTRUCTIONS CAREFULLY AND PASS THEM
ON TO YOUR SUCCESSOR IN THE EVENT OF A CHANGE
IN OWNERSHIP, IN THE EVENT OF MAINTENANCE AND POSSIBLE
REPAIR WORK THEY SHOULD BE PASSED TO THE QUALIFIED
INSTALLER FOR HIS OR HER REFERENCE.
7.1

Mounting the unit

UNIT MUST BE INSTALLED WITH THE PLUMBING
!
CONNECTIONS POINTING DOWNWARD OR UPWARD ONLY.
WARNING: DO NOT INSTALL UNIT WHERE IT WOULD
ROUTINELY BE SPLASHED WITH WATER. ELECTRIC SHOCK
OR DEATH MAY RESULT.
» 1. Install Mini as close as possible to the hot water draw-off
point, for example, directly underneath the sink or next to the
shower stall.
» 2. Install Mini in a frost free area. If frost may occur, remove
unit before freezing temperatures set in.
» 3. Leave a minimum of 5" of clearance on all sides for
servicing.
MINI SERIES TANKLESS ELECTRIC WATER HEATERS |
™
13