Wiring; Set-Up; Identifying The Settings Already Made; Programming The First Somfy Io Local Control Point - SOMFY Variation io Manual Para El Instalador

5. WIRING

- Switch the power supply off.
- Connect the Lighting receiver Variation io to
the mains as per the wiring diagram:
- Mains 230V/50 Hz (A)
- Power supply (AC/DC) (B)
- Control voltage (1-10V) (C)
Blue
A
Brown
Green/Yellow
Cable length

6. SET-Up

This guide describes set-up using only a Situo io type Somfy io local control point. To perform set-up
using a different io control point, refer to the corresponding instructions.
Light on

6.1. Identifying the settings already made

Power must only be supplied to one receiver at a time.
Turn on the power and follow procedure "a" or "b" according
to the light's reaction:
a) The light comes on then goes out
No Somfy io control point has been programmed. Go to the
"Programming the first Somfy io local control point" section.
b) The light does not come on
Press the Up or Down button. If the light comes on or goes
out, the Somfy io control point has been programmed.
Go to the "Use" section.

6.2. Programming the first Somfy io local control point

1) Simultaneously press the Up and Down buttons on the
Somfy io local control point: the light comes on then goes out.
2) Briefly press the PROG button on the Somfy io local
control point: the light comes on then goes out again to
indicate that the Somfy io local control point has been
programmed into the Lighting receiver Variation io.
© 2013 Somfy SAS. All rights reserved. 09/2013
Neutral Blue
B
Live Brown
Earth Green/Yellow
30 cm Cable length
Light off «my» light
position
B
50 cm
A
230V ~
50Hz
30 cm
Neutral Blue
C
Live Brown
Earth Cable length
50 cm
6.2.
50 cm
Dim +
Dim -
50 cm
Feedback
ON
a b
7.
1
2
PROg
+
-
C
7