Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
This ice maker should be installed by qualified personnel.
•
To ensure proper
ventilation
for your ice maker, the front of the unit must be completely
unobstructed.
•
When installing
the ice maker under a counter, follow the recommended
spacing dimensions
shown on the previous
page. Allow 2/5" (10mm)
or more clearance
at rear, 1/5" (5.1mm) at
the sides and 1" (25.4mm)
at the top for proper air circulation.
The installation
should allow
the ice maker to be pulled forward for servicing if necessary.
•
Choose a well-ventilated
area with temperatures
above 45°F (7°C) and below 110° F (43°C).
•
The unit should not be located next to ovens, grills or other sources of high heat.
•
Installation
of the ice maker requires
a cold water supply inlet of 1/4" (6.35mm)
soft copper
tubing with a shut-off valve.
•
The ice maker requires
a continuous
water supply with a minimum
pressure
of 15 psig and a
static pressure
not to exceed 80 psig. The temperature
of the water feeding into the ice maker
should be between 41 °F (5°C) and 90°F (32°C) for proper operation.
Normal operating
ambient temperature
should be between
45°F (7°C) to 110°
F (43°C). Normal operating water temperature
should be between
41 °F (5°C)
and 90°F (32°C). Operation
of the ice maker for extended periods outside of
these normal temperature
ranges may affect production
capacity.
•
In general, it is always a good idea to filter the water. A water filter, if it is of the proper type,
can remove taste and odors as well as particles.
Some water is very hard; softened water may
result in white, mushy cubes that stick together. De-ionized
water is not recommended.
•
The ice maker must be installed with all electrical
and water connections
in accordance
with
all state and local codes.
•
The unit should be located on a firm and level surface. It is important
for the ice maker to be
leveled in order to work properly.
If needed, you can adjust the height of the ice maker by
rotating the casters or adjustable feet. See the Leveling
the Ice Maker section.
•
A standard
electrical
supply (l15V
AC only, 60Hz,
15A), properly
grounded
in accordance
with the National Electrical
Code and local codes and ordinances,
is required.
•
IMPORTANT:
Do not kink or pinch the power supply cord between
the ice maker and wall
or cabinet.
Publicidad
Capítulos
Tabla de contenido
