Franklin Chef FIM35OD Manual Del Usuario página 28

Problem Possible Cause
Cubes are partially
formed or are white
at the bottom.
Not enough water in the
water trough.
The legs are not leveled and
Noise during
locked
operation
Certain sounds are normal.
The electricity is off.
The ice maker stops
suddenly while
making ice.
The body of the ice
maker is electrified.
Scaling occurs
frequently inside
the machine.
The ice maker
makes an alarm
sound regularly.
The room temperature is out
of the stated range.
The ice storage bin is full of
ice.
The drainage tray on top of
the compressor is full.
The ground line isn't in the
socket.
The water is too hard.
The drainage tray on top of
the compressor is full.
Probable Correction
Check if the water supply pressure is
below 15 psig.
Check water supply; filter may be
restricted.
Check for a water leak at the water
trough.
Level and lock the feet. See
"Leveling the Ice Maker".
See "Normal Sounds".
Reconnect the power supply line.
Cut off the electricity; let the ice
maker stop working until the
temperature returns to within the
stated range.
Remove some ice; be sure ice-full
probe is free of ice.
Drain off water by screwing off the
lower drainage nut.
Use a socket meeting the required
electrical standard.
Using a water-softening device
installed in front of the water inlet.
Drain off water by removing lower
drainage nut or back drainage plug.
27