Troubleshooting
Before Calling for Service
If the unit appears to be malfunctioning,
read through the OPERATION
section of this manual
first. If the problem persists,
check the Troubleshooting
Guide below and on the following
page.
The problem
could be something
very simple that can be solved without a service call.
Troubleshooting
Guide
Problem
Possible Cause
Probable Correction
The icemaker is unplugged.
Plug the ice maker in.
Replace fuse-
if this happens, call
The fuse is blown,
for service to check for a short
circuit in the ice maker.
The machine
Turn the Power switch to ON.
doesn't operate.
Remove some ice, making sure the
ice-full probe is free of ice.
Drain off water by screwing off the
lower drainage nut.
Turn on the water supply tap.
The water doesn't
feed in after the
machine starts.
Reconnect
the water supply line.
Clean the condenser.
Check the installation.
Machine
makes ice,
but ice storage
bin
does not fill up with
ice.
Water is leaking
from the unit.
The Power switch is set at OFF.
The ice storage bin is full of
ice.
The drainage tray on top of
the compressor
is full.
The water supply tap is
turned off.
The water supply line is not
properly connected.
Condenser
may be dirty.
The air flow to the ice maker
may be obstructed.
The ambient temperature
and
water
temperature
are high,
or machine is near some heat
source.
A few water drops fall to the
floor when you open the
door to take out ice from
storage bin.
Water supply connection
leaking.
Check the installation.
Normal condensation
on the door or
some water together with ice. Take
care when you take out ice.
Tighten fitting. See "Connecting
the
Water Line".
26