Installation Of Casters; Leveling The Ice Maker - Franklin Chef FIM35OD Manual Del Usuario

Installation of Casters
Casters are provided with the ice maker. They are ideal for rolling the unit from place to place
outdoors. If a mobile installation is chosen, you must install the casters.
Bottom
of unit
Screw holes
Use two or more people when installing or removing casters.
• Tip unit to the right so there is a 3/4-foot clearance at the left of the unit. Have someone to
assist you in tilting the unit, to prevent it from falling on you while installing the casters.
• Screw one of the casters with lock in the front screw impression and screw one of the casters
without lock in the back screw impression.
• Repeat the two steps above with the exception of tipping the unit to the left now, to screw in
the other two casters.
• The casters are now installed.
• The unit should be level. If the floor conditions do not allow the unit to sit level, adjust the
wheel by turning the required wheel counter-clockwise to increase their height and clockwise
to reduce their height.
Leveling the Ice Maker
It is important for the ice maker to be leveled in order
to work properly; otherwise water will not flow as it
should through the evaporator (ice mold). Ice
production will be less than normal, and operation
will be noisy. The ice maker can be raised or lowered
by four leveling legs on the bottom of the machine. If
you find that the surface is not level. You may need to
make several adjustments to level the machine. We
recommend using a carpenter's level to check it.
11
up "_.___J down