Hilti SL 6-A22 Manual De Usuario página 10

5.1.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.1.3 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
5.1.4 Switching on
Whenever you engage the product on the universal hook or mount it on
a tripod, make sure that the product is secure.
▶ Select a mode by pressing the 4-mode switch.
5.1.5 Turning the lamp head
CAUTION
Risk of damage to the eyes (the retina). Looking directly into the lamp
presents a risk of damage to the eyes (the retina).
▶ Do not direct the lamp at yourself or at anyone else.
▶ Do not, under any circumstances, look into the lamp.
CAUTION
There is a risk of crushing fingers in the joint area When the lamp head is
being turned, there is a risk of the fingers being caught between the support
leg and the casing.
▶ Wear protective gloves.
The multi-position hinge and the lamp head can be turned in either
direction along the axis. Do not attempt to force the lamp head past the
end stops.
1. Unlock the multi-position hinge with the locking switch to adjust the lamp
vertically.
2. Then turn the multi-position hinge in the desired direction.
3. Lock the multi-position hinge with the locking switch.
4. Turn the lamp head to the desired position to adjust the lamp horizontally.
6 English
Printed: 22.10.2018 | Doc-Nr: PUB / 5458888 / 000 / 00
2
3
2195846
*2195846*