Description Of Operation; Connecting Charger To Power Supply; Charging The Battery - Stihl KGA 770 Manual De Instrucciones

English

Description of Operation

The power tool is operated with a
rechargeable battery. Use only STIHL
chargers to recharge the battery.
Data exchange
The power tool, battery and charger
communicate with each other. The
charger charges the battery and the
battery supplies the necessary power
only if data exchange functions properly.
For this reason you should operate your
power tool only with the approved STIHL
batteries and STIHL chargers.
38
Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
Insert the mains plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
2
time.
1
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must match – see "Connecting the
charger to the power supply"
Operate the charger only in a closed, dry
space at ambient temperatures of +5 °C
to +40 °C.
Slide the battery (1) into the
N
charger (2) until you start to feel
resistance – then push it in until it
engages
2
KGA 770