Light Emitting Diodes (Led) On Charger - Stihl KGA 770 Manual De Instrucciones

2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic problem or fault
Defekt. Take the battery out of the
power tool and refit it. Switch on the
power tool – if the LEDs continue to
flash, the battery is faulty and must
be replaced.
4)
Electromagnetic problem or fault.
Take the battery out of the power
tool and refit it. Switch on the power
tool – if the light emitting diodes still
flash, the power tool is faulty and
must be checked by a servicing
dealer – STIHL recommends an
authorized STIHL servicing dealer.
KGA 770
Light Emitting Diodes (LED)
on Charger
1
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
Red flashing light ...
... indicates the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"Light Emitting Diodes (LEDs) on
Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends a STIHL
servicing dealer.
English
41