Switching On; Working - Stihl KGA 770 Manual De Instrucciones

English

Switching On

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
Fitting the Battery
1
Insert the battery (1) in the power
N
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching on the Machine
Set the on/off switch to I.
N
Side brooms and roller brush begin to
rotate.
42

Working

Height Adjustment of Side Brooms
The height adjusting knob enables the
side brooms to be set to suit the surface
being cleaned.
Turn the knob to the required
N
setting:
Setting Application
1 - 2 for flat surfaces
3 - 4 damp leaves, sand, uneven
surfaces, e.g. exposed
aggregate concrete
5 - 8 Readjustment to compen-
sate for bristle wear
Side broom bristles must just rest on the
ground. Setting the contact pressure too
high does not produce better cleaning
results, it increases wear and reduces
the battery running time.
Guide Roller
The guide roller makes it easier to
control the sweeper along edges, e.g.
next to walls or curbs.
Hold-Down Device
The hold-down device can be pushed
down to keep the bristles close to the
ground when sweeping along edges,
e.g. next to walls or curbs.
Push down knob on hold-down
N
device.
Thermal Overload Cutout
The thermal overload cutout interrupts
the power supply if the motors are
overloaded, e.g. if a side broom or roller
brush is blocked.
KGA 770