Switching Off; After Finishing Work - Stihl KGA 770 Manual De Instrucciones

If the overload cutout has interrupted the
power supply:
Switch off the machine – position 0 –
N
and remove the battery.
Remove blockage from side brooms
N
or roller brush.
Wait about 30 seconds for overload
N
cutout to cool down.
1
The thermal overload cutout for the side
brooms resets automatically, while the
overload cutout for the roller brush has
to be reset manually by pressing the
switch (1).
Fit the battery and switch the
N
machine on again – set on/off switch
to I.
KGA 770

Switching Off

Switch off the machine – position 0
N
Always remove the battery from the
power tool during work breaks and after
finishing work.
Removing the Battery
2 1
1
Press in both locking tabs (1) at the
N
same time to unlock the battery (2).
Take the battery (2) out of the
N
housing.
When the power tool is not in use, shut it
off so that it does not endanger others.
Secure it against unauthorized use.

After Finishing Work

Removing / Emptying Hopper
Fold the push handle forwards.
N
Pull hopper handle upwards.
N
English
43