Before Machine Start-Up - Nilfisk-Advance Adfinity 17ST Instrucciones De Uso

INSTRUCTIONS FOR USE

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal
1. According to the kind of cleaning to be carried out, the machine can be equipped either with the brush (A, Fig. 2) or the
pad-holder (B) with pad (C) together with the appropriate deck.
2. Press the switch (71) and/or (73) to turn the machine off.
3. Place the brush (A) or the pad-holder (B) under the deck (18).
4. Lower the deck on the brush/pad-holder by pressing the pedal (11).
5. Press the brush/pad-holder switch (71) and the vacuum system switch (73).
6. Push the machine forward to engage the brush/pad-holder, then release the pedal. If necessary, repeat the procedure
until the brush/pad-holder is engaged.
7. To remove the brush/pad-holder, the deck must be lifted by pressing the pedal (11), then press the switch (71) and wait
for the brush/pad-holder to fall on the floor.
If this procedure fails, manually remove the brush/pad-holder from the hub, by turning it in the opposite direction to the
normal rotation direction.
Types of brushes available
17.7 in (450 mm) models
08837020 - Prolene
08837023 - Midlite Grit 180
08837024 - Midgrit 240
08837021 - Prolite
08837022 - Union Mix
Brush/pad application guide (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
14
Figure 2
20.9 in (530 mm) models
08837025 - Prolene
08837028 - Midlite Grit 180
08837029 - Midgrit 240
08837026 - Prolite
08837027 - Union Mix
Midlite Grit 180 Midgrit 240 Prolene Prolite
9096912000(1)2006-09
S311334
Union Mix