Install The Probes - Hach LANGE WDMP sc Manual Del Usuario

Figure 2 AC power disconnect
1 Signal and power junction box
2 AC power access port
3 Cover
10 English
4 Cover latch
5 Power disconnect
6 Electrical conduit
Figure 3 AC power wiring

Install the probes

1. Remove the plastic cap from the end of the probes. Make sure that
the O-ring is in position on the adapter fitting.
2. Install the pH and conductivity probes in the manifold.
3. Connect the probe cables to the junction box. The cables can be
connected in any order. Refer to
4. Configure each probe at the controller. Refer to the individual probe
manuals for configuration instructions.
Figure 4.