Rip Cuts; Bevel Ripping - Delta ShopMaster S36-295 Manual De Instrucciones

RIP CUTS

1. Remove miter gauge
2. Make sure bevel angle is set to 0°.
3. Set blade to correct height for workpiece.
4. Install rip fence and lock it down parallel with and at
desired distance from blade.
5. Keep fingers at least 6 inches from the blade at
all times. When the hand cannot be safely put
between the blade and the rip fence, select a larger
workpiece, or use a push stick and other cutting
aids, as needed, to control the workpiece.
6. Make sure the workpiece is clear of the blade (at
least 1 inch or 25mm away) before starting the saw
7. Turn saw on.
8. Hold the workpiece flat on the table and against the
fence (A). The workpiece must have a straight edge
against the fence and must not be warped, twisted
or bowed. See proper hand position in (Fig. 23).
9. Let blade build up to full speed before moving
workpiece into the blade.
10. Both hands can be used while starting the cut as
long as hands remain 6 inches from the blade.
11. Keep the workpiece against the table and fence
and slowly feed the workpiece rearward all the way
through the saw blade. Do not overload the motor
by forcing the workpiece into the blade.
12. Use the push stick and any other cutting aids, as
needed, to hold the workpiece against the table and
fence, and push the workpiece past the blade. A
push stick is included with this saw, and instructions
are included to make additional push sticks and
other cutting aids.

BEVEL RIPPING

Bevel ripping is the same as ripping except the bevel
angle (A) is set to an angle other than 0°. When making
a bevel rip cut, place the fence on the right side of the
blade so that the blade is tilted away from the fence and
hands.(Fig. 24).
MAKING CUTS
13. Do not push or hold onto the free or cut-off side of
the workpiece.
14. Continue pushing the workpiece until it is clear of
the blade. Do not overload the motor by forcing the
workpiece into the blade.
15. When cut is complete, turn saw off. Wait for blade
to come to a complete stop before removing
workpiece from table.
18
A
FIGURE 23
A
FIGURE 24