Troubleshooting - Corghi EXACT BlackTech X Manual De Uso

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte

TroUBLESHooTING

The equipment shows no signs of
life
Mains voltage incorrect or not present
➥ Check the electrical system and hook-up the
equipment correctly.
Plug not fitted into socket correctly
➥ Connect the plug properly.
PC feeder not switched on
➥ Switch on the PC feeder using the button on
the rear of the PC.
Incorrect power supply voltage selected
➥ Set the power supply voltage jumper to the
correct position, check also the power supply
of the transformer.
Monitor power switch is set to OFF
➥ Set the monitor power switch to ON.
Monitor is not receiving power
➥ Renew the monitor fuse.
System does not move on from
opening screen
Press the keypad ESC key
➥ Press the alphanumeric keypad "ESC" key.
KEYPAD
Keypad not accepting commands
Keypad connection cable is not connected
➥ Make sure the cable is connected to the com-
puter inside the aligner correctly.
Possible faulty keypad
➥ Call the service centre.
Steering wheels not straight
Compensation routine performed incorrectly
➥ Repeat compensation taking care that the
corresponding wheel on the opposite side
of the vehicle does not rotate or steer (in the
case of steer wheels).
CALIBrATIoN
➥ Call the service centre and do not use the
wheel aligner.
rEmoTE CoNTroL
Programme does not change when keys are
pressed
Battery flat
➥ Replace the battery.
Operator's manual EXACT BlackTech X
Distance between remote control and central
unit too great
➥ Move closer: max distance 6m.
Remote control pointing in wrong direction
➥ Point the remote control towards the eye of
➥ Hold the remote control properly.
Too much ambient light
➥ Move closer.
Printer switch "OFF"
➥ Turn the printer switch to "ON".
No power
➥ Check that the printer plug is connected cor-
Cable crushed between steel plate parts
➥ Position the cable correctly.
Printer in standby status, "on line" LED off
➥ Press the "ON LINE" button to illuminate the
Print target failure
➥ Call the service centre.
Ink ribbon worn out or broken
➥ Change the cartridge, following the instructions
No paper
➥ Fit fresh sheets of paper, following the instruc-
the "Spare Parts" manual does not authorise
the user to do any work on the machine except
for that specifically described in the operator's
manual, but does enable the user to provide
accurate information to the after-sales service,
in order to reduce service times.
http://www.eichstaedt-elektronik.de
the receiver.
PrINTEr
Does not switch on
rectly.
Switches on but does not print
LED.
Does not print properly
Printing too pale
in the printer manual.
"Error" LED on - "Error" LED
flashing
tions in the printer manual.
WARNING
EN
75