Corghi EXACT BlackTech X Manual De Uso página 67

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
the real situation of the car.
normal display mode.
(11) Front axle measurement
(Fig. 23)
To access this function from the rest of the pro-
gramme select the
Level the targets and adjust the angles by bring-
ing the values within the tolerance range (numeri-
cal data and graph bar coloured green).
The 2 front axle measurement screens display
the front caster, front camber, front half toe, front
total toe and front set-back angle values.
In the rear axle measurement screen,
switches between the two pages of values.
cyclically displays only one value pair
at a time. In this phase, the angle symbol shows
the real situation of the car.
normal display mode.
For adjustment of the caster the data, only avail-
able if the steering lock measurement procedure
has been carried out, must be on the screen.
The data are only shown when the front targets
are levelled.
N.B. On exit from this procedure the caster values
are saved automatically.
Saving of these values means that the procedure
can always be restarted from the last adjust-
ment made.
If a new steering lock procedure is performed, the
values recalled will be the last ones measured
during the steering lock sequence.
(12) Second angle measurement
with steering locked
Repetition of the steering axis angle measurement
allows you to check whether errors have been
introduced during adjustment of the caster.
The procedure is exactly the same as the first time
the caster, king pin and steering angle difference
values were measured.
Performing the steering lock procedure or
moves the programme straight on to
front axle measurement.
Operator's manual EXACT BlackTech X
returns to
icon or the F1 key.
returns to
http://www.eichstaedt-elektronik.de
(13) Second front axle
measurement
Repetition of the front axle measurement proce-
dure allows any corrections to the adjustments
already made.
(14) Printout of the data measured
(Fig. 42)
To access this function from the rest of the pro-
gramme select the
The printout serves to inform the customer about
the operations performed and as a reference for
subsequent checks on the vehicle.
Fill in the heading of the job record
and print and/or save the job done using the
appropriate commands.
when the printout is complete, end the job and
return to the main menu
job for any further adjustments.
(15) Graphic printouts
The current printed report, supplied in alphanu-
meric form, has now been updated with the addi-
tion of two annexes consisting of graphics which
illustrate some information about the vehicle in
intuitive form.
The first annex, entitled "Vehicle Situation",
shows the toe, camber and setback values before
and after adjustment.
The second annex, entitled "Chassis Situation",
lists the set-back, track difference, wheel base
difference, side offset and offset values of the
axles after adjustment.
The "Print \ Type" field of the user set-up can
be set appropriately to select the annexes to
be printed:
• "Alphanumeric" prints the alphanumeric pages
only.
• "Vehicle Situation" prints the alphanumeric
report and the vehicle situation annex. This
setting is indicated by the
print page status bar.
icon or the F4 key.
or restart the
EN
icon in the
67