Remote Control; Personal Computer; Important - Corghi EXACT BlackTech X Manual De Uso

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
- Remote control receiver: point the remote
control in this direction before pressing any
keys.
- Remote control: wheel aligner remote control
unit.
- Personal Computer: contains and executes
the vehicle wheel alignment program. Also
contains the wheel aligner control electron-
ics.
- Printer: allows the results of the job done to
be recorded on paper.
- Aligner card, card to enable aligner opera-
tion. The second slot is used for the cards
provided in the update kits.
- Power supply plug.
- Electrical board.
- Frame grabber card in the PC.
working screen (Fig. 23)
A) Title (e.g. FRONT AXLE): indicates the pro-
cedure being used.
B) Values measured on the vehicle.
C) Databank values.
D) Graphic comparison between the values
measured and databank values.
E) Target level indications (LEVELS).
F) Representation of the angles currently being
measured.
G) HELP: command which recalls the on-line
help function.
H) Icon bar: icons you can use to move around
the program. More information about the
selected icon is provided in the feedback
bar.
I) Feedback bar: displays a help message about
the function of the selected icon.
L) Vehicle name bar: displays the name of the
vehicle selected from the databank. During
selection of the vehicle from the databank,
it shows the market selected.
M) Status bar: displays system messages.
N) Axle value difference: window containing the
value and databank reference for the differ-
ence between the right-hand and left-hand
values of the angle measured. The window
only appears when the databank contains a
reference value.
O) Operating Zone: part of the screen which
displays the working information.
Operator's manual EXACT BlackTech X
A) Handle for locking the target to the clamp.
The clamps function in the same way as ordinary
self-centring clamps.
Use the handles (C, Fig. 26) to fix the clamp to
the rim or remove it.
The release lever (A, Fig. 26) can be used to
lower the target connection point to prevent
particularly low spoilers from interfering with
the measurements (Fig. 27).
To fix the target at the required height, tighten
the fixing screw (B, Fig. 26) with the target in the
position desired.
These clamps are also able to operate on cars
with wrap-around fenders (Citroen); in this case,
mount the clamps in the horizontal position.
On small-diameter rims, always perform compensa-
tion with the clamps in the horizontal position.
with the keys Enter, Esc and the four arrows, re-
peat the functions of the same keys of the keypad
and the control panel of the central unit.
It is powered by an ordinary 9V DC battery.
Turn on the aligner using the main switch.
wait a few seconds to allow the monitor to switch
on and the computer to load the program.
The personal computer, and thus the entire
wheel aligner, can only be switched off using
the command provided in the wheel alignment
program.
Switching off the personal computer without
using the command provided may damage the
software installation.
When the wheel aligner is switched off using the
software command, the PC, the monitor and the
printer switch to standby status. To switch off
these devices completely, use either the rela-
tive on and off buttons, or the PC feeder switch
(switch marked C turned to 0), or cut off the
wheel aligner power supply at the mains.
http://www.eichstaedt-elektronik.de
Target (Fig. 24)
Clamps

rEmoTE CoNTroL

PErSoNAL ComPUTEr

IMPORTANT

IMPORTANT
EN
49