Safety Instructions; General Guidelines; User Manual; Front Panel - HQ-Power PROMIX50U Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
Introduction
1.
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.

Safety Instructions

2.
Keep the device away from children and unauthorised users.
Indoor use only.
Keep the device away from rain, moisture, splashing and dripping liquids, extreme
heat and dust. Never put objects filled with liquid on top of or close to the device.
Be very careful during the installation: touching live wires can cause life-threatening
electroshocks. The device should only be installed and serviced by a qualified person.

General Guidelines

3.
Refer to the Velleman
 Protect this device from shocks and abuse. Avoid brute force when operating the device.
 Contact a local dealer for spare parts.
 This mixer should only be used indoors with the included PSU or with a PSU of the same rating.
 Make sure that the available voltage does not exceed the voltage stated in the specifications of this
manual and printed on the device.
 Do not crimp the power cord and protect it against damage. Refer to an authorised dealer for
replacement.
 Disconnect the device from the mains to clean or when not in use. Handle the power cord by the plug or
adaptor only.
 Do not switch the device on immediately after it has been exposed to changes in temperature.
Allowing the device to stabilise to room temperature before switching it on avoids damage.
 Familiarise yourself with the functions of the device before actually using it.
 All modifications of the device are forbidden for safety reasons.
 Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Please be sure to leave a space to allow for heat radiation. The distance between rear panel and other
objects must be > 5 cm. The distance between sides and other objects must be > 3 cm.
Make sure the ventilation holes with objects are free and clean at all times.
Overview
4.
Refer to the illustrations on page 2 of this manual.
1
Mic Bal.
Balance adjustment between Mic 1 and Mic 2.
2
Mic Level
Volume adjustment of the microphone signal.
3
Channel 1
Fader for channel 1.
V. 02 – 20/06/2019

USER MANUAL

®
Service and Quality Warranty on the last pages of this manual.
PROMIX50U

FRONT PANEL

3
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido