Safety Instructions; Front Panel And Controls (Fig. 1); Rear Panel And Controls (Fig. 2) - HQ-Power PROMIX100 Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
You have chosen an excellent multifunctional stereo mixer which meets the most stringent requirements for
both home and professional applications. It is equipped with one control function per level allowing all
connected components to be tuned individually. The output display will facilitate your choice of level.
2.

Safety Instructions

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
This unit uses potentially lethal voltages. Do not open the cabinet in order to avoid electroshocks.
Do not expose to the sun or other heat sources for any period of time.
Handle the controls with care: avoid rough movements and do not drop or smash the set.
The connections between the mixer and the rest of the equipment should be checked carefully. Faulty
connections or defective shielding may cause buzzing sounds.
3.

Front Panel and Controls (Fig. 1)

Refer to the illustrations on page 2 of this manual.
1 POWER switch
2 OUTPUT DISPLAY
3 MONITOR switch
4 Monitor LEVEL control
5 Headphone jack
6 Volume control for LINE 4
7 Volume control for LINE 3
8 Input selector for PHONO 2 or LINE 2
4.

Rear Panel and Controls (Fig. 2)

16 Power supply cable
17 Record output jacks L/R REC
18 Main output jacks L/R AMP
19 Input jacks L/R LINE 4
20 Input jacks L/R LINE 3
5. Connections
All connections have to be made correctly in order for the device to work properly.
1. If you wish to turn the device off, simply put the "POWER" switch (1) in the "off" position. All connections
must be established when the device is off. In other words, make sure that all linear controls (4, 6, 7,
10-13) are at zero.
2. Insert the supply cable plug (20) into the current socket.
3. All necessary inputs are connected to cinch plugs through shielded cables. The output jacks are connected
to a stereo unit, also through shielded cables.
4. Microphones: up to 4 microphones can be connected to this mixer through the 6.35 mm plugs (14, 15,
26, 28). Please use a suitable adapter if your microphones are equipped with a different type of plug.
5. Compact disc players, cassette recorders, video recorders, tape recorders and other high level audio signal
sources as well as amplifiers should be connected to the cinch sockets (23, 24).
V. 1.1 – 12/04/2013
PROMIX100
USER MANUAL
9 Input selector for PHONO 1 or LINE1
10 Volume control for PHONO 2 or LINE 2
11 Volume control for PHONO 1 or LINE 1
12 Volume control for MIKE 2 and MIKE 4
13 Volume control for MIKE 1 and MIKE 3
14 6.3 mm jack for MIKE 1
15 6.3 mm jack for MIKE 2
21 Input jacks L/R PHONO 2 or LINE 2
22 Input jacks L/R PHONO 1 or LINE 1
23 6.3 mm jack for MIKE 4
24 6.3 mm jack for MIKE 3
25 Earth terminal screw: counters humming sounds.
3 ©Velleman nv