Power Cord - Pioneer AVH-X7700BT Manual De Instalación

Connection
This product
1
3
2
4
8 7 6
1 Pioneer navigation system
Please contact your dealer to 4 m inquire about the connect-
able navigation unit.
2 RGB cable(Supplied with Navigation system)
3 Microphone 4 m
4 This product
5 Antenna jack
6 Power supply
7 Fuse (10 A)
8 Wired remote input
Hard-wired remote control adapter can be connected (sold
separately).

Power cord

2
2*
5
4*
3
5
7
8
9
a (5*)
g
1.
i
l
1 To power supply
2 Depending on the kind of vehicle, the function of 2* and 4*
1
1* 3 Yellow (2*)
4 Yellow (1*)
5 Red (4*)
3*
6 Red (3*)
7 Connect leads of the same color to each other.
8 Orange/white
4
9 Black (ground)
6
a Blue/white (5*)
c
b Blue/white (6*)
b (6*)
d
c Blue/white
e
f
d Violet/white
2.
e Yellow/black
f Light green
h
j
g Connection method
h Power supply side
i Parking brake switch
k
j Ground side
k Speaker leads
may be different. In this case, be sure to connect 1* to 4*
and 3* to 2*.
Back-up (or accessory)
Connect to the constant 12 V supply terminal.
Accessory (or back-up)
Connect to terminal controlled by ignition switch (12 V DC).
To lighting switch terminal.
To vehicle (metal) body.
The pin position of the ISO connector will differ depending
on the type of vehicle. Connect 5* and 6* when Pin 5 is an
antenna control type. In another type of vehicle, never con-
nect 5* and 6*.
Connect to auto-antenna relay control terminal (max. 300
mA 12 V DC).
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
Of the two lead wires connected to the back lamp, connect
the one in which the voltage changes when the gear shift
is in the REVERSE (R) position. This connection enables
the unit to sense whether the car is moving forwards or
backwards.
If you use an equipment with Mute function, wire this lead
to the Audio Mute lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the
parking brake switch.
1 Clamp the lead.
2 Clamp firmly with needle-nosed pliers.
White: Front left + or high range left +
White/black: Front left – or high range left –
3