Connecting The Power Cord - Pioneer AVH-8400BT Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
Section
01
Connecting the units

Connecting the power cord

Navigation system
(AVIC-F220 (sold
separately))
Please contact your dealer to
inquire about the connectable
navigation unit.
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two. In this case, be sure to connect to both connectors.
4
En
26 pin cable (Supplied with navigation unit)
Insert the 26 pin cable in the direction
indicated in the figure.
2*
1*
4*
3*
Yellow (2*)
Yellow (1*)
Back-up
Connect to the constant 12 V
(or accessory)
supply terminal.
Red (4*)
Red (3*)
Accessory
Connect to terminal controlled by
(or back-up)
ignition switch (12 V DC).
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
Fuse (10 A)
Antenna input
This product
AUX jack (3.5 ø)
Use a mini plug cable to connect with
auxiliary device.
Connect leads of the same
color to each other.
Speaker leads
Front left 
White:
Front left 
White/black:
Front right 
Gray:
Front right 
Gray/black:
Rear left  or subwoofer 
Green:
Rear left  or subwoofer 
Green/black:
Rear right  or subwoofer 
Violet:
Rear right  or subwoofer 
Violet/black:
4 m
RGB input

Publicidad

Tabla de contenido
loading

Tabla de contenido