Hitachi M 12VC Instrucciones De Manejo página 13

When using the router along the interior
plane of the template, the dimensions of the
finished product will be less than the
dimensions of the template by an amount
equal to dimension "A", the difference
between the radius of the template guide
and the radius of the bit. The reverse is frue
when using the router along the exterior of
the template.
Secure the template to the workpiece. Feed
the router in the manner that the template
guide moves along the template as shown
in Fig. 12.
(2) Straight guide (optional accessory)
Use straight guide for chamfering and
groove cutting along the materials side.
1 Insert the guide bar into the hole in the bar
holder, then lightly tighten the 2 wing bolts
(A) on top of the bar holder.
2 Insert the guide bar into the hole in the base,
then firmly tighten the 2 hex socket bolts
(standard accessories).
3 Make minute adjustments of the dimensions
between the bit and the guide surface with
the feed screw, then firmly tighten the 2
wing bolts (A) on top of the bar holder and
the wing bolt (B) that secures the straight
guide. (Fig.13)
4 As shown in Fig. 14, securely attach the
bottom of the base to processed surface of
the materials. Feed the router while keeping
the guide plane on the surface of the
materials.
5. Cutting
WARNING:
Wear eye protection when operating this tool.
Keep your hands, face and other body parts away from the bits and any other rotating
parts, while operating the tool.
(1) The bit must be kept clear of the materials
which are to be cut, when the power is being
turned on. (Fig. 15)
(2) Then turn the tool on and wait until the bit
attains full speed.
A
Fig. 12
Guide Bar
Hex
Socket
Bar
Bolt
Holder
Guide
Straight
Plane
Guide
Fig. 13
Fig. 14
Separate
Fig. 15
English
Template Guide
Template
Feed Screw
Wing
Bolt (A)
Wing
Bolt (B)
13