Black and Decker HSMC1321 Manual De Instrucciones página 10

English
4. To use, follow instructions under hand-held steam
cleaning.

Do not use the steam glove
WARNING:
without a cleaning pad in proper position.
Figure P
35
16
Hand-held steam cleaning
1. Turn off and unplug steam mop. After allowing it to
cool down, remove the hand-held steam cleaner
from the steam mop body
2. Attach the required accessory.
nOTiCE: The unit will not produce steam unless an
accessory hose is fitted.
3. Plug hand-held steam cleaner electric cord into the
outlet.
4. Press the ON/OFF button
seconds for the hand-held steam cleaner to heat up.
• When you have finished using the hand held steam
cleaner, turn it 'OFF,' and unplug it. Wait until it cools
(approximately five minutes) before reattaching to
steam mop body.
Fabric Steamer
The fabric steamer allows you to steam and press clothes,
linens, and upholstery.

WARNING: Burn hazard, do not touch the metal
plate on the steam distributor. It will cause severe
injury. Allow plate to cool for at least 20 minutes
before removing or attaching any accessories.

WARNING: Burn hazard, do not use the fabric
steamer on clothes that are being worn.
1. Insure fabric steamer base
are cool and not attached to hand-held steam cleaner
2. Attach the fabric steamer base to the hose
Ensure the accessory has snapped securely into place.
3. Place the steam distributor directly on the fabric
steamer base so the two prongs
the base (figure Q).
8
36
12
2
10 .
1 . It takes approximately 15
and steam distributor
25
(figure G).
11
37 clip securely onto
Figure Q
25
4. Snap the lint brush
Ensure that the four brush clips
of the fabric steamer base.
Figure R
5. To use, follow instructions under hand-held steam
cleaning. Move the brush and steam distributor along
the fabric to steam clean and remove wrinkles (figure S).
NOTE: To ensure the steamer is safe for a fabric, first test it
in an inconspicuous area of the item you are to use it on.
Figure S
Carpet refreshing

WARNING: It is important to monitor the water
level in the water tank. To refill the water tank and
continue to sanitize/ clean, return the handle tube
to the upright position and turn the steam mop 'OFF'.
Unplug the unit from the wall outlet, and refill the
water tank.

CAUTION: Never leave the steam mop in one spot on
any surface for any period of time.
26
1. Place the carpet glider
.
2
2. Lightly press the steam mop with attached cleaning pad
down onto the carpet glider (figure T).
Figure T
26
37
27 securely into place (figure R).
38 are on the long side
38
28 on the floor.
6