Black and Decker HSMC1321 Manual De Instrucciones página 8

English
ATTACHING PAD TO SQUEEGEE - Fig. I

Burn hazard, do not use the
WARNING:
squeegee and pad on clothes that are being worn.

Wait until steam cleaner cools
CAUTION:
down to attach or remove the squeegee pad.
(approximately five minutes)
NOTE: The squeegee pad
squeegee.
NOTE: To ensure the steamer is safe for a fabric, first test it in an
inconspicuous area of the item you are to us it on.
1. Attach the hose 11 to the steam cleaner as described
for figure F.
2. Attach the squeegee
figure G.
3. Hook the squeegee pad
the squeegee and stretch it to the other side of the
squeegee as shown in figure I. Ensure the pad fully
covers the squeegee.
Figure I
34
REMOVING ACCESSORIES FROM THE HOSE
• For accessories other than the steam nozzle, turn hand
held steamer off, unplug, and allow to cool down. Then
twist accessory counterclockwise then pull away from
the hose.
Attaching the carpet glider - Fig. J
1. Place carpet glider on the floor.
2. Lightly press the steam mop with attached cleaning
pad down onto the carpet glider
21
into place.
Removing the carpet glider

CAUTION: Always wear suitable shoes when
changing the carpet glider on your steam mop. Do not
wear slippers or open-toed footwear.
1. Return the handle tube
the steam mop to 'OFF', and unplug.
2. Wait until steam mop cools down (approximately five
minutes). Place the front of your shoe onto the carpet
glider removal tab 34
3. Lift the steam mop up off the carpet glider.
6
34 works only with the window
to the hose as described for
33
34 around one side of
33
until it clicks
28
to the upright position, turn
6
and press down firmly.
Figure J
FILLING THE WATER TANK
NOTICE: Fill the water tank with regular tap water.
NOTICE: In areas of very hard water, the use of
de-ionized water is recommended.

Do not over fill the tank.
WARNING:
1. Ensure that the appliance is switched off and the power
cord is disconnected from the power supply.
2. Open the filler cap
4
3. Fill the water tank with water.
4. Close the filler cap.
NOTICE: Always empty the water tank after use.
NOTICE: Fill the water tank with clean tap water (Do not
use any additives or chemicals).

WARNING: When filling, detach from main unit
and maintain in a horizontal position.

WARNING: Your water tank has a 0.5 litre capacity.
Do not over fill the tank.
NOTICE: Ensure the filler cap is firmly secured.
Figure K
OPERATION

CAUTION: FOR FLOOR AND HAND HELD USE ONLY;
DO NOT USE THE UNIT UPSIDE DOWN.
Switching on/off
It takes approximately 15 seconds for the steam
NOTICE:
mop to heat up.
• To switch the appliance on, press the ON/OFF button
then turn the Smartselect.dial
• To switch the appliance off, turn the Smartselect.dial to
off, then press the ON/OFF button.
NOTICE: Never leave the steam mop in one spot on
any surface for any period of time. Do not store with
a wet pad as this can damage your floor. Always place
the steam mop with the handle tube
position when stationary and make sure the steam
mop is turned off and unplugged when not in use.
NOTICE: Always empty the water tank after use.
21
28
34
by pulling up (figure K).
4
to the desired setting.
3
6 in the upright
,
1