Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Figure D
2
Attaching a cleaning pad - Fig. E
Replacement cleaning pads are available from your
BLACK+DECKER dealer (cat. no. SMP20).
•
Place a micro-fiber cleaning pad
the 'hook & loop' side facing up.
•
Press steam mop down onto the cleaning pad. You are
now ready to steam clean and sanitize your floor.
nOTiCE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle tube
6
in the upright position when stationary and make sure the
steam mop is turned off and unplugged when not in use.
Figure E
21
Removing a cleaning pad - Fig. E
CAUTION: Always wear suitable shoes when
changing the cleaning pad on your steam mop. Do
not wear slippers or open-toed footwear.
1. Return the handle tube
turn the steam mop 'OFF'.
2. Wait until it cools down. (approximately five minutes)
3. Place the front of your shoe onto the cleaning pad
removal tab
and press down firmly.
29
4. Lift the steam mop up off the cleaning pad.
nOTiCE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle tube
in the upright position when stationary and make sure the
6
steam mop is turned off and unplugged when not in use.
Hand-held steam cleaner attachments
NOTICE: Remove the hand-held steam cleaner from the
steam body after turning off and unplugging the steam
mop, and after allowing the steam mop to cool down.
Attaching the hose and steam glove -
Fig. F
1. Firmly press the hose (
of the hand-held steam cleaner such that it is fully
seated.
2. To remove, depress the hose release button
pull the hose out of the hand-held steam cleaner.
9
10
21
on the floor with
29
to the upright position and
6
11
or
14
) onto the steam nozzle
30
WARNING: Inspect the seal 31 on the
handheld steam cleaner 2 and the seal 32 at
the end of the hose before each use (figure F).
If the seal is missing or damaged contact your
nearest authorized repair agent. Do not use the
appliance.
CAUTION: Ensure that the hose is securely
fastened before using the hand-held steam cleaner.
Figure F
ATTACHING OTHER ACCESSORIES TO
THE HOSE - Fig. G
1. For other accessories other than the steam nozzle, align the
lugs
31
2. Press the accessory onto the hose and twist clockwise until
the accessory is fully seated and clicks into place.
Figure G
Attaching steam jet nozzle - Fig. H
1. Press in the clips
2. Align the two keys on the inside flange of the steam jet
nozzle with the two slots at the end of the hose
3. Firmly press the steam jet nozzle onto the hose such that
it is fully seated, and release the clips.
4. To remove, press the clips and pull the steam jet nozzle
away from the hose.
WARNING: Inspect the seal on the steam nozzle of the
hose before each use (figure H). If the seal is missing or
damaged contact your nearest authorized repair agent.
Do not use the appliance.
CAUTION: Ensure that the hose and/or steam nozzle
is securely fastened before using the hand-held steam
cleaner.
Figure H
, and
32
11
31
30
on the hose with the recesses on the accessory.
31
32
on the steam jet nozzle
32
English
24
.
11
.
5
Publicidad
Capítulos
Tabla de contenido
