To Clean And Lubricate The Drill Stand; To Adjust The Drill Motor Carriage - Husqvarna DMS 240 Manual Del Usuario

To clean and lubricate the drill stand

CAUTION If you do not clean the drill stand,
it can become damaged.
1. Remove the drill motor.
2. Clean the drill stand with a high pressure washer
and then remove remaining water with a dry cloth.
3. Lubricate the moving parts on the drill stand. Apply
grease to the contact surfaces to prevent corrosion.

To adjust the drill motor carriage

If there is play between the drill column and the drill
motor carriage, the drill motor carriage must be
adjusted.
1. Remove the plastic covers from the top and bottom
of the drill motor carriage.
2. Loosen the set screws that hold the roller shafts.
898 - 002 - 20.06.2019
3. Start with the top roller shaft. Use a flat screwdriver
and turn clockwise to move the roller shaft nearer to
the drill column.
4. Tighten the set screw to lock the roller shaft.
5. Adjust the lower roller shaft, turn the screw
counterclockwise to move the roller shaft nearer to
the drill column.
6. Tighten the set screw to lock the roller shaft.
7. Use the feed lever to see if the drill motor carriage
moves smoothly on the drill column. If not, adjust the
roller shafts again.
8. Install the plastic covers to the top and bottom of the
drill motor carriage.
35