Owner Responsibility; Product Description; Drill Stand; Introduction - Husqvarna DMS 240 Manual Del Usuario

Introduction................................................................... 22
Safety............................................................................25
Assembly...................................................................... 31
Installation.....................................................................31
Operation...................................................................... 32

Owner responsibility

WARNING Processing of concrete and
stone by methods such as cutting, grinding
or drilling, especially during dry operation,
generates dust that comes from the material
being processed, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, use water to
bind the dust, when feasible. If dry operation
is necessary, use an appropriate dust
extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
22
Contents
Maintenance................................................................. 34
Troubleshooting............................................................ 36
Transportation and storage...........................................36
Technical data.............................................................. 37
Service..........................................................................38

Introduction

National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.

Product description

The product is an electrical drill motor for concrete brick
and different stone materials. It is used with a drill stand.
Drill motor and drill stand

Drill stand

• The drill stand is used when you make holes in walls
and floors.
• The drill stand has an installation plate that makes
the drill motor easy to attach.
• The bottom plate is made of aluminum.
• The wheel kit can be removed.
• The drill column can be tilted 0-60°.
• The transmission of the feed lever housing is
adjustable. The higher position gives 2.5:1 and the
lower, 1:1.
898 - 002 - 20.06.2019