Blades; General; Transport And Storage - Husqvarna TS60 US Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General

WARNING! Blades can break and cause
!
serious injuries to the user. Diamond blades
become very hot when used. An overheated
blade is a result of improper use, and may
cause deformation of the blade, resulting in
damage and injuries.
Do not use an overheated blade.
Make sure that the correct bushing is used for the cutting
blade to be fitted on the machine. See the instructions
under the heading Assembling the cutting blade.
The blades should be marked with the same or a higher
speed than that stated on the machine's rating plate.
Never use a blade with a lower speed rating than that of
the machine.
When using diamond blades make sure that it rotates in
the direction indicated by the arrow on the blade.
Diamond blades consist of a steel core provided with
segments or a continuous rim containing industrial
diamonds.
Suitable blades
8" or 10" continous rim blade. 8" profile wheel.

BLADES

Blades for different materials
WARNING! Never use a blade for any other
!
materials than that it was intended for.
Cutting plastics with a diamond blade can
cause kickback when the material melts due
to the heat produced when cutting and
sticks to the blade. Never cut plastic
materials with a diamond blade!
Blade selection should be made according to the material
being cut. Ask your dealer for help in choosing the right
product.
Blade vibrations
The blade can become out of round and vibrate if a too
high feed pressure is used.
A lower feed pressure can stop the vibration. Otherwise
replace the blade.
Sharpening diamond blades
Always use a sharp diamond blade.
Diamond blades can become dull when the wrong feeding
pressure is used or when cutting certain materials such as
heavily reinforced concrete. Working with a dull diamond
blade causes overheating, which can result in the
diamond segments coming loose.
Sharpen the blade by cutting in a soft material such as
sandstone or brick.

Transport and storage

Remove the blade before transportation or storage of the
machine.
Store the blade in a dry place.
Inspect new blades for transport or storage damage.
– 7
English

Publicidad

Tabla de contenido
loading

Tabla de contenido