Assembling And Adjustments; General - Husqvarna TS60 US Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS

General

Place the TS60 on a flat, horizontal and stable surface to
prevent the equipment from tipping over, sliding or walking on
the surface.
• Mount the frame legs together using the bolts. The legs
can be folded together for easier transport.
• Adjust the working height by releasing the spring loaded
quick connector and slide the inner tube to wished height.
• Lift the saw on the stand. The slot on the saw must be
aligned with the groove on the stand.
• Use the two clamps, one on each side, to fasten the frame
on to the stand.
8 –
English
• The machine can also be used without frame legs or
placed on a workbench.
• Pull out the locking knob on the conveyor cart.
• Slide the conveyor cart onto the frame. Make sure that the
support rollers sit correctly in the slot.
• When the locking knob past the lug on the frame, push the
locking knob in to allow the conveyor cart to slide all the
way in.
• Fit the side table using the supplied screws.
If the side table is not in level with the conveyor cart it may
need adjustment. Adjust using the screws.
• Screw the cutting guide onto the conveyor cart. The guide
can be folded outwards for angled cuts. Use the angle
markings on the cutting guide to set the correct angle.