Cutting Blades; Diamond Blades; To Adjust The Position Of The Operation Handles - Husqvarna FS 4600 G II Manual De Usuario

Cutting blades

WARNING:
for other materials than which it is made for.
WARNING:
for wet cutting. The diamond blade must be
applicable to the same speed or a higher
speed than the value given on the product.
Only use diamond blades that are in
compliance with national or regional
standards, for example EN13236 or ANSI
B7.1.
The cutting blade manufacturer gives warnings and
recommendations for the operation and correct
maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.

Diamond blades

WARNING:
diamond blade rotates in the direction of the
arrows shown on the diamond blade.
CAUTION:
diamond blade.
There is a wide range of diamond blades that is used for
different operations. From new made concrete to
concrete and asphalt that has become hard and for
different hardness classes.
Diamond blades has a steel core with segments that are
made of industrial diamonds.
Water cooling system
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
The water cooling system is also used to keep the
temperature of the gearbox down.
CAUTION:
operate at idle speed for more than 2–3
14
Do not use a cutting blade
Only use diamond blades
Make sure that the
Always use a sharp
Do not let the engine
minutes when the water cooling system is
off. The gearbox can become too hot without
water supply.
To sharpen the diamond blades
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause the
diamond segments to come loose.
• Decrease the cutting depth and the engine speed for
a short time to sharpen the diamonds on the
diamond blade.
Diamond blades for wet cutting
WARNING:
dimension that is specified for the current
blade dimension. Do not use blade flanges
that are damaged.
During the operation, the friction causes the diamond
blade to become very hot. If the diamond blade
becomes too hot, it will decrease the blade tension or
make the core crack.
Let the diamond blade become cool before you touch it.
• Diamond blades for wet cutting must be used with
water to keep the diamond blade core and segments
cool during cutting. Diamond blades for wet cutting
can not be used dry.
• If you use diamond blades for wet cutting without
water, the diamond blade can become too hot. This
gives bad performance, blade damage and is a
safety risk.
To adjust the position of the operation
handles
1. Turn the locking knob (A) counterclockwise.
C
B
D
2. Select between 3 operation position (B), (C) or (D).
For position (C) and (D), pull out and adjust the
operation handle to applicable operation position.
Always use a blade flange
A
1657 - 001 - 08.09.2021