General Safety Precautions; Work Area Safety; Electrical Safety - Husqvarna DMS 240 Manual De Instrucciones

Ocultar thumbs Ver también para DMS 240:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General safety precautions

WARNING! Read all safety warnings and all
!
instructions. Failure to follow the warnings
and instructions may result in electric
shock, fire and/or serious injury.

Work area safety

Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases
or dust. Power tools create sparks which may ignite the
dust or fumes.
People and animals can distract you causing you to lose
control of the machine. For this reason, always remain
concentrated and focused on the task.
Do not use the machine in bad weather, such as dense
fog, heavy rain, strong wind, intense cold, etc. Working in
bad weather is tiring and can lead to dangerous
conditions, e.g. slippery surfaces.
Never start to work with the machine before the working
area is clear and you have a firm foothold. Look out for any
obstacles with unexpected movement. Ensure that no
material can become loose and fall, causing injury when
operating the machine.
Always check the rear side of the surface where the drill
bit will emerge when drilling right through. Secure and
cordon off the area and make sure that no one can be
injured or material damaged.
8 –
English
SAFETY INSTRUCTIONS

Electrical safety

WARNING! There is always a risk of shocks
!
from electrically powered machines. Avoid
unfavourable weather conditions and body
contact with lightning conductors and metal
objects. Always follow the instructions in the
Operator's manual to avoid damage.
WARNING! Do not wash the machine with
!
water, as water can enter the electrical
system or the engine and cause damage to
the machine or short circuit.
The machine should be connected to an earthed outlet
socket.
Check that the mains voltage corresponds with that stated
on the rating plate on the machine.
Check that the cord and extension cord are intact and in
good condition. Use an extension cord intended for
outdoor use.
Never use the machine if the cord is damaged, hand it in
to an authorized service workshop for repair.
To avoid overheating do not use the extension cord while
it is rolled up.
Never carry the machine by means of the cord and never
pull out the plug by pulling the cord.
Keep all cables and extension leads away from water, oil
and sharp edges. Make sure the cable is not jammed in
doors, fences or the like. Otherwise it can cause the
charger to become live.
The power tool should not be exposed to more moisture
than what is provided by the water system. Do not expose
the power tool to rain. Water entering a power tool will
increase the risk of electric shock.
Ensure the cord is behind you when you start to use the
machine so that the cord will not be damaged.

Publicidad

Tabla de contenido
loading

Tabla de contenido