Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna DMS 240 Manual De Instrucciones

Symbols on the machine:

WARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or fatal
injury to the operator or others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
• Breathing mask
This product is in accordance with applicable
EC directives.
Environmental marking. Symbols on the
product or its packaging indicate that this
product cannot be handled as domestic
waste. It must instead be submitted to an
appropriate recycling station for the recovery
of electrical and electronic equipment.
By ensuring that this product is taken care of
correctly, you can help to counteract the
potential negative impact on the environment and people that
can otherwise result through the incorrect waste
management of this product.
For more detailed information about recycling this product,
contact your municipality, your domestic waste service or the
shop from where you purchased the product.
Ensure that water cannot leak into the
machine when drilling in the ceiling. Use an
appropriate water collector and cover the
machine in plastic, but do not cover the air
intakes and air outlets.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
2 –
English

KEY TO SYMBOLS

Symbols in the operator's manual:

Inspection and/or maintenance should
be carried out with the motor switched
off and the plug disconnected.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.