Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Controls a nd Features
4
f
Muffler
Air Filter
Choke
Throttle
OiJDrain
Fuel Fill
l
Recoil Starter
Handle
OiJDrain
NOTE: Engine models
may vary in features and/or
location
of
controls.
The following
is to serve as a general
reference.
Always
supplement
this information
with the operator's
manual that
is included
with the product
for more information
regarding
specific
controls
and their location.
ChokeControl
Activating
choke control
by sliding it all the way to the right
closes the choke plate on carburetor
and aids in starting
engine.
For information
on choke usage, see "Starting
The Engine".
The image above corresponds
with the label on the engine
identifying
the Choke control.
RecoilStarter& Starter Handle
This motor is fitted with a recoil action pull start and a mitten
grip handle for easy access while wearing
gloves or mittens.
Figure 4-1
Ignition Key
NOTE:The
existence
and location
of an ignition
key may vary by
product.
Refer to your product
operator's
manual for specific
key
inclusion
and/or location
information.
Insert the key, if so equipped,
and snap it into place; do not turn
the key to attempt
to start/stop
the unit. Pull the key out halfway
to stop the engine. Remove key when the unit is not in use.
Oil Fill
On some models
the oil fill is located
at the top of the engine, as
seen in the lower portion
of Fig. 4-1. On some other models,
it is
located
on the bottom
of the engine
block as seen in the upper
portion
of Fig. 4-1. Remove oil cap to add oil. Refer to "Pre-
Operation
Check" section for checking
oil and "Maintaining
Your
Engine" section
for adding
oil instructions.
Publicidad
Capítulos
Tabla de contenido
