Drawing; Accessories; Explanation Of Symbols - Vermeiren Inovys II-F Manual De Instrucciones

Storage and use temperature
Storage and use humidity
We reserve the right to introduce technical changes. Measurement tolerance ± 15 mm / 1,5 kg / °
The wheelchair complies to the requirements set up in:
ISO 7176-8: Requirements and test methods for static, impact and fatigue strengths.
To remain compliant to EN12183, make sure that the mounted seating system meets the
necessary requirements of the MDD 93/42/EEC.
1.3

Drawing

1.4

Accessories

The following accessories are available for the Inovys II-F:

Wooden table (B12)

Hemiplegic armrests (B66)
Contact your specialist dealer about other accessories. He will gladly advise you.
1.5

Explanation of symbols

Maximum mass
Indoor and outdoor use
Maximum Safe Slope
CE conformity
Type designation
Not intended to be used as a seat in a Motor vehicle
Table 1: Technical specifications Inovys II-F
Page 5
+ 5 °C
30%
1 = Pushing handgrips
2 = Push bar
3 = Back frame
4 = Arm pads
5 = Armrests
6 = Brakes
7 = Tip cap
8 = Rear wheels (driving wheels)
9 = Frame
10 = Front wheels (steering wheels)
11 = Seat frame
12 = Leg rests
13 = Footrests
14 = Identification plate
Inovys II-F
2016-05
+ 41 °C
70%