Position Wheels - Vermeiren Inovys II-F Manual De Instrucciones

Ⓐ Front tube
The basic frame and the seat frame are screwed together with the front tube Ⓐ. In the basic
frame three different sockets are provided for these screws which determine the
wheelchair's seat height.
Ⓑ Attachment plate gas pressure spring
In addition to adjusting the frame, the gas pressure spring for the seat inclination can be
fixed at three different attaching heights Ⓑ. So that the angle of inclination can be kept for
the seat inclination, the assembly height of the gas pressure spring Ⓑ must correspond to
the assembly height of the front tube Ⓐ.
Ⓒ Rear wheel plate
The rear wheel plate Ⓒ must correspond to the assembly height of the front tube Ⓐ.
3.5

Position wheels

L
WARNING:
Risk of tipping over – Be aware that you change the stability of the
wheelchair when changing the position of the driving wheels.
L
WARNING:
Risk of injury – Make sure that the rear wheels on both sides are
mounted in the same position.
The wheel sockets in the frame tubing Ⓒ serve only to attach 16" wheels (transit version).
The stability or manoeuvrability of the wheelchair can be adjusted over 50 mm.
STEERING WHEELS
In the standard model, the INOVYS II-F is delivered with two 8" steering wheels (200 mm x
50 mm or 200 mm x 35 mm).
DRIVING WHEELS
Four possible wheel sockets are provided in a
swage block of the frame for the use of driving
wheels (24") Ⓐ, (22") Ⓑ. Depending on which
suspensions are used to attach the driving
wheels, the wheel
manoeuvrability of wheelchair: 45 mm). The
wheel sockets attached in the delivery condition
can be attached in all sockets (bore holing).
Page 17
Inovys II-F
2016-05
position (stability or