Operating The Brakes; Mounting Or Removing Of Armrests - Vermeiren Inovys II-F Manual De Instrucciones

2.6

Operating the brakes

L
WARNING:
The brakes are not used to slow down the wheelchair during
movements – Use the brake only to prevent the wheelchair from unintended
movements.
L
WARNING:
Good operation of the brakes is influenced by wear and
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
L
WARNING:
The brakes are adjustable and can wear – Check the operation of the
brakes before each use.
2.7

Mounting or removing of armrests

L
CAUTION:
Risk of clamping – Keep fingers, buckles and clothes away from the
bottom side of the armrest.
To apply the brakes:
Push the brake levers  forward till you feel a
1.
distinctive click.
L
CAUTION:
Risk of unintended movement –
Make sure the wheelchair is on a flat
horizontal surface before releasing the
brakes. Never release both brakes
simultaneously.
To release the brakes:
Release one brake by pulling the lever 
1.
backwards.
2. Hold the hand rim (if available) of the release
wheel with your hand.
3. Release the second brake by pulling the lever
 backwards.
The armrests of the wheelchair can be mounted by
following instructions.
Pull out the star knob .
1.
2. Mount the armrest from above into the
provided bracket .
Let go of the star knob .
3.
Turn the star knob  clockwise until it is finger-
4.
tight.
5. Check that the armrest is firmly secured.
The armrests of the wheelchair can be removed by
following instructions.
Turn the star knob  anti-clockwise.
1.
Pull out the star knob .
2.
Remove the armrest out the bracket .
3.
Let go of the star knob .
4.
Page 9
Inovys II-F
2016-05