Adjust The Seat Depth - Vermeiren Inovys II-F Manual De Instrucciones

3.6

Adjust the seat depth

L
WARNING:
Risk of injury – Make sure that all screws are secure and properly
tightened.
The seat depth can be adjusted in 3 positions (steps 20 mm). Adjust the seat depth
according following rules:
Note: When rebuilding the seat depth in the back frame area, the displacement of the spring
for adjusting the back is changed and a gap can occur between the back and seat cushions.
The seat depth can also be changed by adjusting the brackets . With these adjustment you
can become a minimum seat depth of 460 mm.
Depending on the backrest that is chosen by the customer, above assembly instructions may
deviate.
Seat depth Hole
480 mm
500 mm
520 mm
1. Loosen the screws Ⓐ beneath the
front seat frame.
2. Pull or push the front of the seat frame into
the desired position.
3. Retighten the screws Ⓐ firmly again.
1. Remove the backrest.
2. Loosen the bolts  of the four
brackets.
3. Adjust the brackets more to the front
or back until the desired seat depth.
4. Retighten the bolts  of the four
brackets.
5. Replace the backrest.
Page 18



Table 3: Seat depth
Inovys II-F
2016-05