Home Canning Tips; Oven Controls - Haier QAS740 Manual Del Usuario

Cocina eléctricas compactas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE RANGE
SURFACE UNITS (Cont.)

Home Canning Tips

Be sure the canner is centered over the surface unit.
Make sure the canner is flat on the bottom.
To prevent burns from steam or heat, use caution when
canning.
Use recipes and procedures from reputable sources. These
are available from manufacturers such as Ball® and Kerr® and
the Department of Agriculture Extension Service.
Flat-bottomed canners are recommended. Use of water bath
canners with rippled bottoms may extend the time required
to bring the water to a boil.

OVEN CONTROLS

Oven Mode Selector Knob
Turn the Oven Mode Selector knob to the mode you want.
Your oven has the following cooking modes: Bake Broil and
Convection Bake. See Cooking Modes section and Steam
Clean for more information.
• Bake
• Broil
• Convection Bake
• Steam Clean
Oven Mode Selector Knob (knob appearance may vary)
49-88074-1
Oven Temperature Knob
Turn the Oven Temp knob to the setting you want until
Oven/Cycle light turns off.
The Oven/Cycle light comes on when the burner is on. It will
cycle on and off during cooking.
To Adjust the Thermostat:
1.
Pull the Oven Temp knob off the range and look
at the back side. To make an adjustment, loosen
(approximately one turn), but do not completely remove,
the two screws on the back of the knob.
2.
With the back of the knob facing you, hold the outer
edge of the knob with one hand and turn the front of the
knob with the other hand.
To increase the oven temperature, move the top screw
toward the right. You'll hear a click for each notch you
move the knob.
To decrease the oven temperature, move the top screw
toward the left.
Each click will change the oven temperature
approximately 10°F. (Range is plus or minus 30°F from
the arrow.) We suggest that you make the adjustment
one click from the original setting and check oven
performance before making any additional adjustments.
3.
After the adjustment is made, retighten screws so they
are snug, but be careful not to overtighten.
4.
Replace the knob, matching the flat area of the knob to
the shaft, and check performance
Front of OVEN TEMP knob
(knob appearance may vary)
Back of OVEN TEMP knob
(knob appearance may vary)
11

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido