Machine Operation; Pre- Operation; Scrubbing Floors - Tennant T1 Manual Del Operario

OPERATION
EN

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.

PRE- OPERATION

1. Inspect power cord for damage.
2. Sweep and dust-mop the floor.
3. Check that the brush and squeegee blades are
installed.

SCRUBBING FLOORS

WARNING: Fire or Explosion Hazard, Do Not
Use or Pick Up Flammable Materials.
1. Pull the handle adjustment lever and adjust the
handle to a comfortable operating height (Figure
11). Release the lever to lock the position.
FIG. 11
2. Lower the scrub head to the floor by stepping on
the transport release pedal (Figure 12).
FIG. 12
8
3. Press the main power switch to the on ( I ) position
(Figure 13).
4. Press the scrubbing mode switch towards the
vacuum/brush/solution mode (Figure 14).
FIG. 13
5. To begin scrubbing, pull the start triggers and push
or pull the machine in either direction (Figure 15).
FOR SAFETY: When operating machine, do not run
machine over power cord.
FIG. 15
6. When stopping, release the triggers and continue
to move the machine to pick up all solution.
7. View the water pickup from the recovery window
(Figure 16). When the water pickup stops, unplug
the power cord and empty the recovery tank.
The machine is equipped with a vacuum shut- off
float that will automatically stop the water pickup
should the water level reach the full point. A
sudden change in vacuum motor sound will occur.
ATTENTION: Check for excessive foam in the
recovery tank. Empty tank if excessive. Foam may
not activate the shut- off float which may result in
vacuum motor damage.
FIG. 14
Tennant T1 (03- 08)