Malaguti Madison3 125ie Manual De Uso página 158

5.15 FUSES
• The electrical equipment includes eight fuses protecting the
main components against faults. These are located in the
glove compartment (Fig. 43). They are:
A) 15 A
B) 7.5 A
1
C) 3 A
D) 5 A
ACC.MOTOR
10 A
2
E) 30 A
F) 10 A
3
G) 7.5 A
H) 3 A
5 A
4
• To replace a fuse, open the lower fairing cover, remove the
blown fuse and replace it with one of the same capacity. Inside
the lower fairing compartment, you will find some spare fuses.
Check that the fuse you are using has the same amperage of
5
the fuse you are replacing.
• The vehicle features another main protection fuse (30 A) lo-
cated beside the battery (Fig. 43b).
6
If the main protection fuse blows during use, check how seri-
ous the causes are. Then have the vehicle checked by an
Authorised MALAGUTI Service Centre.
48
Lights
Stop light + turn indicators
Control unit
Relay
Engine accessories (version 125cc)
Main
Coil - Fuel pump - Injector - Lambda
Not used (125cc version)
Fan
Main control unit power supply
Socket (125cc version)
Do not replace the fuse with one having a higher capac-
ity, as it could seriously damage the electrical equipment
and cause a fire on the vehicle in the event of a short
circuit.
If the fuses blow, even if they have been replaced, have
them checked by an Authorised MALAGUTI Service
Centre.
(250cc version only) Every time the power supply is
reconnected after replacing or removing a fuse (E - C -
H), perform the CONTROL UNIT SETUP PROCEDURE (see
§ 5.16.1 on page 49).
15
A
7.5
A STOP
3
A M.I.U.
5
A
ACC.MOTOR
30
PRINCIPAL
A
10
A PUMP AT.I.L.
7.5
A
3
A M.I.U.
ENGLISH
A B C D E F G H
15 A
7.5 A STOP
3 A M.I.U.
5 A ACC.MOTOR
30 PRINCIPAL
A
10 A PUMP AT.I.L.
7.5 A
3 A M.I.U.
Fig. 43
Fig. 43b