Whirlpool Vantage WED7990XG Manual De Uso página 18

First try the solutions suggested here or visit our website at www.whirlpool.com/help
If you experience
Dryer will not run
Is the dryer door firmly closed.
Was the start button firmly
touched.
Has a household fuse blown, or
has a circuit breaker tripped?
Is the correct power supply
available?
Was a regular fuse used?
Unusual sounds
Has the dryer had a period
of non-use?
Is a coin, button, or paper clip
caught between the drum and
front or rear of the dryer?
Is it a gas dryer?
Are the four legs installed, and
is the dryer level front to back and
side to side?
Is the clothing knotted or balled up?
No heat
Has a household fuse blown, or has
a circuit breaker tripped?
Is the valve open on the gas supply
line on gas models?
Dryer displaying code message
"PF" (power failure), check the
following:
"F" Variable (F1, F2, F20, etc.)
service codes:
"L2" Diagnostic Code (low or no
line voltage condition):
18
for assistance and to possibly avoid a service call.
Possible Causes Solution
Open door, reclose firmly, and press START.
Make sure Start button was firmly pressed.
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
Electric dryers require 240-volt power supply. Check with
a qualified electrician.
Use a time-delay fuse.
If the dryer hasn't been used for a while, there may be a
thumping sound during the first few minutes of operation.
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
The gas valve clicking is a normal operating sound.
The dryer may vibrate if not properly installed.
See "Installation Instructions."
When balled up, the load will bounce, causing the dryer to vibrate.
Separate the load items and restart the dryer.
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace both
fuses or reset the circuit breaker. If the problem continues, call an
electrician.
For gas dryers, is the valve open on the supply line.
Was the drying cycle interrupted by a power failure? Touch and
hold START to restart the dryer.
Call for service.
The drum will turn, but there may be a problem with your home
power supply keeping the dryer's heater from turning on. The
dryer will continue to run when this diagnostic code is present.
Touch any key to clear the code from the display and return to
the estimated time remaining.
Try the following:
Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use two household fuses or breakers.
Replace the fuse or reset the circuit breaker.
In the U.S.A., Confirm the power cord is properly installed. Refer
to "Electrical Connection" in the Installation Instructions for
details.
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.