Signs And Symbols Used; Putting Into Operation - Abicor Binzel MB EVO PRO Serie Instructivo De Servicio

4 Putting into operation

3.2 Signs and symbols used

The following signs and symbols are used in the operating instructions:
Symbol Description
• Bullet symbol for instructions and lists

Cross reference symbol refers to detailed, supplementary or further information
1 Step(s) described in the text to be carried out in succession
A Step(s) described in the figure to be carried out in succession
4 Putting into operation
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance,
servicing, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the coolant supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
DANGER
Risk of injury and machine damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if the device is handled
by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
NOTICE
• Please take note of the following instructions:
 3 Product description auf Seite EN-4
The MIG/MAG manual welding torch is equipped upon delivery. For information about
replacing wear parts, refer to the following chapter:
 8.2 Cleaning the cable assembly auf Seite EN-15
EN - 6
MB EVO PRO/MB EVO
BAL.0414.0 • 2018-08-01