Polaris Quattro Manual De Uso página 15

Problem
Cleaner is sluggish, running with less
power than normal or not
Cleaner does not climb walls.
Smooth Surface Pools (tile, fiberglass, etc.)
Problem
Not enough traction on smooth
surface pools (tile,
fiberglass, etc.).
Solution
1. Check the wheel RPM. Target wheel speed is
28-32 RPM. If wheel speed is not in target range,
moving. refer to Section 7 Adjust Wheel Speed.
2. Check for debris in the filter canister and clean, if
necessary.
3. Check the filter screen and the in-line filter and
clean, if necessary.
4. Clean the skimmer basket, pump basket, and pool
filter.
5. Check all of the hoses, connections, and swivels for
leaks that could cause loss of water pressure.
1. Check the wheel RPM. Target wheel speed is
28-32 RPM. If wheel speed is not in target range,
refer to Section 7 Adjust Wheel Speed.
2. Ensure the hose is floating and the hose floats
are positioned properly. Position the first float (k)
up against the feed hose connector (j) and then
space hose floats 1-3 ft (30-90 cm) apart.
3. Check for debris in the filter canister and clean, if
necessary.
4. Adjust the thrust jet. Refer to Section 8 Fine
Tuning.
5. For smooth surface pools (tile, fiberglass, etc.),
replace both rear tires with PosiTrax
more traction (available from a Polaris
Solution
Replace both rear tires with PosiTrax tires for more
traction (available from a Polaris dealer).
tires for
®
dealer).
®
15