General Description; Preparation For Use; Initial; Supply Voltage - HT HT10 Manual De Instrucciones

2. GENERAL DESCRIPTION

The instrument performs the following measurements:
 DC Voltage with 2-wire method
 AC Voltage with 2-wire method
 AC Voltage with 1-wire method (polarity detection)
 AC Voltage measurement with low impedance value
 Phase sequence indication
 Resistance measurement
 Continuity test with buzzer
The measurement result is displayed with indication of the measuring unit both in
numerical mode and on the LCD display. A white pointer LED is also available in order to
correctly perform the tests even in poorly lit environments.

3. PREPARATION FOR USE

3.1.

INITIAL

This instrument was checked both mechanically and electrically prior to shipment. All
possible cares and precautions were taken to let you receive the instrument under perfect
conditions. However we suggest you to check it rapidly (any damage may have occurred
during transport). Make sure that all standard accessories mentioned in § 7.3 are included.
Should you have to return the instrument for any reason please follow the instructions
mentioned in § 7.
3.2.

SUPPLY VOLTAGE

The instrument is powered by 2x1.5V alkaline batteries type AAA LR03. When batteries
are low, a low battery indication "
instructions of § 6.2
3.3.

STORAGE

After a period of storage under extreme environmental conditions exceeding the limits
mentioned in § 6.2.1 let the instrument come back to normal measuring conditions before
using it.
" is displayed. To replace batteries please follow the
EN - 5
HT10