Resistance Measurement - HT HT10 Manual De Instrucciones

5.7.

RESISTANCE MEASUREMENT

Before measuring resistance remove power from the circuit under test and
discharge all capacitors.
1. Perform the preliminary Autotest function (see § 4.4)
2. Press and hold the
are displayed
3. Connect the L1 and L2 probes to the object under test (see Fig.10). The resistance
value is shown at display
4. Press the H/ key to activate/deactivate the function HOLD at display. Press and hold
the H/ key in order to activate/deactivate the display backlight
5. Press the / key to activate/deactivate the white LED torch
6. Press and hold the
CAUTION
Fig. 10: Resistance measurement
/ key to switch on the instrument The "OL" and "" symbols
/ key to switch off the instrument
EN - 14
HT10