Resistance Measurement And Continuity Test - HT 60 Manual De Instrucciones

4.3.3. Resistance measurement and Continuity test

Before attempting any resistance measurement, cut off power supply from
the circuit to be measured and make sure that all capacitors are discharged,
if present.
Fig. 4: Use of the instrument for resistance measurement and continuity test
1. Select position CAP
2. Insert the red cable into input terminal VHz%CAPTemp 
into input terminal COM.
3. Position the test leads in the desired spots of the circuit to be measured (see Fig. 4).
The display shows the value of resistance.
4. The message
measurable value.
5. Press the MODE key until symbol
connect the instrument as for Resistance measurement. The continuity buzzer
activates for R<30.
6. To use the HOLD function, see § 4.2.
O.L. indicates that the value of resistance exceeds the maximum
" "
CAUTION
is shown in order to activate continuity test and
" "
EN - 10
HT60
and the black cable