Lubrication - RK Rose+Krieger DuoLine S Clean Instrucciones De Montaje

7.4.1 Lubrication

1
Section slide lubrication
The guide slides are lubricated directly via the grease
nipples.
Clean grease and oil from the lubrication point before
lubricating.
Ensure that the grease gun is axially aligned with the
flow direction of the funnel-type lubricating nipple.
A high pressure grease gun with an extrusion tip must
be used to lubricate the RK DuoLine 60 and 80 units.
Recommended lubricants:
Grease with viscosity class according to DIN 51818:
NLGI class 1
NLGI class 00
Application in max. area:
Grease with viscosity class according to DIN 51818:
NLGI class 2
Maintenance/re-greasing
Version
DuoLine 60
DuoLine 80
* Grease in two stages. After the first stage, drive the guide slides through three slide lengths and
then top up with the second stage.
Recommended lubricating interval taking the environmental factors and loading data specified in
these assembly instructions into consideration
** Grease in two stages. After the first stage, drive the guide slides through two slide lengths and
then top up with the second stage. Recommended lubrication interval under the environmental
influences and loading data specified in these assembly instructions.
2
Spindles are lubricated directly via the grease nipple.
Clean grease and oil from the lubrication point before
lubricating.
Ensure that the grease gun is axially aligned with the
flow direction of the funnel-type lubricating nipple.
A high pressure grease gun with an extrusion tip must
be used to lubricate the RK DuoLine 60 and 80 units.
Recommended lubricants:
Grease with viscosity class according to DIN 51818:
NLGI class 1
NLGI class 00
Application in max. area:
Grease with viscosity class according to DIN 51818:
NLGI class 2
Track rail guide*
(Lubricate every 1000 km)
3
2 x 0.8 cm
3
2 x 1.4 cm
Spindle lubrication
Spindle**
(Lubricate every 300 km)
–
3
2 x 2.5 cm
7. Life Phases 7. Life Phases 7. Life Phases
65 65 65