Publicidad
Idiomas disponibles
Idiomas disponibles
(A) Main body; (21) Handlebar; (37)
Handlebar stem; (41) Saddle post;
(40)
Horizontal
Saddle; (14) Rear stabiliser bar with
adjustable feet; (16) Front stabiliser
bar with wheels; (11-L) Left pedal; (11-
R) Right pedal; Monitor casing and
components; (10) Slot head bolt M 10;
(9) Flat washer M 10; (8) Cap nut M
10; Double ended spanner.
2. Position the machine's rear stand
on the rear stabiliser bar (14), as
shown in Fig.2, insert the bolts (10), fit
the flat washers (9) and cap nuts (8)
and then tighten securely.
3, Position the front stabiliser bar with
wheels (16), paying attention to the
red dots and with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (10), fit the flat washers (9) and
cap nuts (8) and tighten securely.
2.- FITTING THE HANDLEBAR.-
Position the handlebar (21) on the
handlebar stem (37), Fig.3, tighten the
knob
(52)
and
handlebar stem (37) into the hole on
the main body (A), Fig.3. Position it
correctly and then tighten knob (Y) by
turning it clockwise.
3.- ATTACHING THE SADDLE.-
Fit the saddle bracket (1), Fig.4, onto
the horizontal saddle tube (40), as
shown in Fig.4, fit the saddle into
position and tighten the nuts on the
bracket securely. Next insert the
horizontal saddle tube (40) through
the hole on the saddle post (41), Fig.4,
position it correctly and tighten the
knob (S), Fig.4. Insert the saddle post
(41) into the boss on the main body
(A), position it correctly and tighten the
saddle post by using the adjustment
knob (T), Fig.4, turning it clockwise.
saddle
tube;
then
insert
4.- FITTING THE PEDALS.-
The assembly instructions for the
(1)
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (11-R), marked
with the letter (R), screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely, Fig.5.
The left-hand pedal (11-L), marked
with the letter (L), screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten
securely, Fig.5.
5.- ATTACHING THE BOTTLE
HOLDER.-
Remove screws (30) located on the
main post (A) and fi i t the bottle holder
(29) Fig.6, using the same screws
the
(30).
6.- ATTACHING THE MONITOR.-
Position the bracket (28-1) on the
handlebar (21), as shown in Fig.7, and
tighten.
Place the monitor (28) and the bracket
(28-1), as shown in Fig.7.
Connect terminal (28-2) of the middle
cable to terminal (28-0) of the cable
sticking out of the monitor (28) Fig.8.
EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control (Z),
located on the stem of the main body
(A), Fig.9. This
exertion
clockwise.
10
provides various
settings
when
turned
Publicidad
